Table of Contents
Advertisement
Figure 91. Removing an expansion card from the Riser 1a
Figure 92. Removing an expansion card from Riser 2a
NOTE:
The procedure to remove the expansion card from Riser 2a, 2d and 2e is same.
3. If the expansion card is not going to be replaced, install a filler bracket and close the card retention latch.
NOTE:
You must install a filler bracket over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components
129
Advertisement
Table of Contents
