Table of Contents
Advertisement
3. Hold the card by the edges, and align the card edge connector with the expansion card connector on the riser.
4. Insert the card edge connector firmly into the expansion card connector until the card is fully seated.
5. Close the expansion card retention latch.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 97. Installing an expansion card into a Riser 1a
Figure 98. Installing an expansion card into a Riser 2a
NOTE:
The procedure to install the expansion card into Riser 2a, 2d and 2e is same.
132
Installing and removing system components
Advertisement
Table of Contents
