Table of Contents
Advertisement
Figure 73. Set the anti-tilt wires to the locked position and tightening the captive nuts
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Expansion cards and expansion card risers
NOTE:
When an expansion card is not supported or missing, the iDRAC and Lifecycle Controller logs an event. This does
not prevent your system from booting. However, if a F1/F2 pause occurs with an error message, see Troubleshooting
expansion cards section in the PowerEdge Servers Troubleshooting Guide at www.dell.com/poweredgemanuals.
After working inside your
system.
Installing and removing system components
113
Advertisement
Table of Contents
