Dell PowerEdge R660xs Installation And Service Manual page 31

Table 33. No BP Configuration with iDRAC
Dell PowerEdge Server Standard
Operating Support (ASHRAE A2
compliant) All options supported
unless otherwise noted.
● 25G OCP3.0 NIC with 4 ports or
PCIe cooling tier higher than or
equal to 5 could only support optic
transceiver with thermal spec 85C
and power <=1.2W ( DPN: M14MK)
● 25G OCP3.0 NIC with PCIe cooling
tier lower than 5 could not support
spec 70C optic transceiver with
power higher than 1.2W ( DPN:
0YR96)
Table 34. 4 x 3.5-inch SAS/SATA Configuration with iDRAC
Dell PowerEdge Server Standard
Operating Support (ASHRAE A2
compliant) All options supported
unless otherwise noted.
● STD Fan is required.
● STD HSK is required for CPU Base
TDP <=150W
● HPR HSK is required for CPU Base
TDP >150W
● 2-processor all configs or 1-processor
with Rear storage module config
requires 7x fans
● 1-processor without Rear storage
module config requires 5x fans
● HW restriction is required for CPU
Base TDP >205W
○ Front storage moduleonly support
2x3.5 at HDD#0, HDD1 and HDD
Blank F3F7V x 2 are required at
HDD#2 and HDD#3
○ RIO only support PCIe1 and
OCP3.0. Could not support
BOSS, PCIe2 and PCIe3.
○ With Rear storage module config
only support max. 30C ambient.
● Only support DDR5 DIMM up to 64G.
● 100G PCIe NIC could not
support MFS1S00-VxxE (spec 75C)
transceiver.
● 100G PCIe and OCP3.0 NIC could
only support optic transceiver with
thermal Spec 85C and power
<=2.5W
● 25G PCIe NIC could only support
optic transceiver with thermal Spec
85C and power <=1.2W
● 25G OCP3.0 NIC with 4 ports or
PCIe cooling tier higher than 5 could
only support optic transceiver with
thermal spec 85C and power <=1.2W
● 25G OCP3.0 NIC with PCIe cooling
tier lower than or equal to 5 could
Dell PowerEdge Server Extended
Inletient 40° C Operating Support
(ASHRAE A3 compliant)
● Optic Transceiver with spec 85C is
required
● Two PSUs are required. System
performance may be reduced in the
event of a PSU failure
Dell PowerEdge Server Extended
Inletient 40° C Operating Support
(ASHRAE A3 compliant)
● Not support CPU Base TDP > 150W
● STD Fan is required.
● STD HSK is required
● Not support BOSS M.2 Module
● Not support Non-Dell qualified
peripheral cards and Channel devices
(FW) cards
● Not support NIC consuming power
>= 25W.
● Not Support Config with Rear
storage module
● Not support OCP transfer rate >25G
or cooling tier > 10
● Optic Transceiver with spec 85C is
required
● Two PSUs are required. System
performance may be reduced in the
event of a PSU failure
Dell PowerEdge Server Extended
Inletient 45° C Operating Support
(ASHRAE A4 compliant)
Dell PowerEdge Server Extended
Inletient 45° C Operating Support
(ASHRAE A4 compliant)
● Not support
Technical specifications 31