Device Alerts
Devices which are capable of reporting alerts (sensor devices) can con gure basic high and low level thresh-
old alerts on the device alerts page. These alerts are recorded in the event log and can be emailed or sent by
text message using the system email sender.
To con gure an alarm:
1. Select the sensor type.
2. Turn on the high alert and/or low alert switch.
3. Enter the high and/or low alert values.
4. Check the Enabled box to enable the alert.
Alerts will only be sent once each time they are activated.
1
2
3
1. Sensor Channel
Select the sensor channel to con gure the alert limits.
2. High Alert
If sensor value meets or exceeds this value trigger a high-alert.
3. Low Alert
If sensor value meets or falls below this value trigger a low-alert.
4. Enable Checkbox Check to enable the alerts for this sensor channel.
5. Save Button
When highlighted Green, there are changes that are not saved.
Press the Save button to save the changes to system memory.
23
© Agrowtek Inc. | www.agrowtek.com | Technology to Help You Grow™
5
4
Need help?
Do you have a question about the GrowControl GCX and is the answer not in the manual?