Installing A Psu; Removing And Installing A Board - H3C WX6103 Installation Manual

CAUTION:
The PSU is rather heavy, so use one hand to support its weight when pulling it out with the other hand.
•
If the PSU slot is to remain empty, install a blank filler panel to prevent dust from getting in and ensure
•
good ventilation of the chassis.

Installing a PSU

Follow these steps to install a PSU:
Put on an ESD-preventive wrist strap and take a new PSU out of the package. Check that the PSU
Step1
conforms to the power input.
With one hand holding the PSU handle and the other hand supporting the bottom of the PSU, gently
Step2
push it into the chassis along the slot until it is in good contact with the PSU connector on the backplane.
CAUTION:
Insert the PSU straight and steadily. Make sure the PSU is not inserted upside down.
•
To avoid breaking or tilting the PSU terminals, if the PSU is not well aligned with the connector on the
•
backplane, be sure to pull it out and insert it again.
Tighten the captive screws to sec1( bet(54 l0.000f0P)2i(t)6(e bacehat . sur)8( )-60( ) ] T J0 Tc 0 Tw 6 0 0 44101.04 5
Step3
41