H3C WX6103 Installation Manual page 77

| Change The HyperTerminal's Baudrate Accordingly
|---------------------------<Baudrate Avaliable>------------------------- |
|<1> 9600(Default)*
|<2> 19200
|<3> 38400
|<4> 57600
|<5> 115200
|<0> Exit
==========================================================================
Enter your choice(0-5):
Select an appropriate baud rate. For example, select 5 for 1 15200 bps. The following information
Step2
appears:
Baudrate has been changed to 115200 bps.
Please change the terminal's baudrate to 115200 bps, press ENTER when ready.
The serial interface baud rate of the access controller has been changed to 1 15,200 bps while that of the
terminal is still 9,600 bps, the access controller and the terminal cannot communicate with each other.
Change the baud rate to 1 15,200 bps in HyperTerminal.
Disconnect the terminal connection in HyperTerminal, as shown in
Step3
Figure 49 Disconnect the terminal connection
Choose File > Properties. In the Properties dialog box, click Configure... and select 1 15,200 in the Bits
Step4
per second drop-down list.
69
|
Figure 49:
|
|
|
|
|
|