Unpack The Operator - HySecurity Nice SlideSmart CNX 15 Installation And Programming Manual

Slide gate operator
Table of Contents

Advertisement

UNPACK THE OPERATOR

UNPACK THE OPERATOR
1. Open the box and remove the front cover, chain
cover, rear cover, edge sensor, photo eye, chain
hardware kit, and ship with kit.
2. Check the contents of the ship with kit:
a. Basic Manual
b. UL 325 required gate safety signs and zip ties
c. DASMA gate safety literature
d. Rear cover mounting hardware
e. Cover keys
f.
Chain cover lock pin
g. Optional 208/230VAC and 24VDC voltage labels
3. Lift the chassis using the lift handles.
Chain Cover
Rear Cover
Lift Handle
Note: You can mark the slots and conduit area on the
plywood underneath the chassis and then use the
plywood as an anchor hole template.
PLYWOOD (MINIMUM PAD SIZE)
BOTTOM OF CHASSIS
CONDUIT AND
ANCHOR HOLE AREA
12
support.hysecurity.com
GENERAL OPERATOR DIMENSIONS
Front Cover
15 3/8"
(38 cm)
(COVER DEPTH)
W
20 7/8"
(53 cm)
(COVER WIDTH)
H
24 1/2"
(62 cm)
(OPERATOR
HEIGHT)
L

Advertisement

Table of Contents
loading

Table of Contents