Install The Operator - HySecurity SlideDriver II 15 Quick Start Manual

INSTALL THE CHASSIS
WARNING
Obtain help before lifting or moving the operator.
SlideDriver II models can weigh over 260 lbs (118
kg). Failure to comply may result in serious injury to
personnel, damage to the equipment, or both.
1. Align the operator. Locate rear panel 1½ in from the
face of vertical uprights.
2. Install concrete anchors (½ x 4 in min.). 2 anchor
bolts required per cross support. 3 anchor bolts
required per cross support for heavy gates (80V and
200V).
3. Tighten the nuts, but leave room for adjustments.
4. Level the operator. Shim with a corrosion resistant
material such as aluminum or plastic.
CAUTION
Do NOT fully tighten the anchor bolts until after the
drive rail is installed.
Rear panel
Anchor bolts
(½ x 4 in, min.)
Minimum 4
anchor bolts
(6 bolts required
for heavy gates:
80V and 200V
operators.)

INSTALL THE OPERATOR

HYDRAULIC HOSE SWAP
NOTICE
Do not operate SlideDriver II gate operators while the
hoses are disconnected. Make sure that all hydraulic
hoses are securely installed before operating the
motor.
Level
Side view
SlideDriver II is set to Right
Hand configuration by
default.
Swap hydraulic hoses for
Left Hand configuration.
MX5384 Rev. B ©2023 7