Checking For Leaks; Hydraulic Fluid Capacity; Changing The Hydraulic Fluid - Toro Reelmaster 5010-H Operator's Manual

1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Tilt the seat; refer to
3. At the left side of the machine, align a drain pan
under the charge filter
Figure 117
1. Filter head
4. Remove the filter.
5. Wipe clean the filter mounting area of the filter
head.
6. Apply a thin coat of the specified hydraulic fluid
to the gasket of the new charge filter.
7. Thread the filter onto the filter head by hand until
the gasket contacts the mounting surface, then
rotate the filter an additional 1/2 turn by hand.
8. Lower and latch the seat; refer to
Seat (page 50).

Checking for Leaks

1. Start the engine and run it for 2 minutes to purge
air from the hydraulic system.
2. Shut off the engine, remove the key, and check
for leaks at the return and charge filters.
Note:
Repair all hydraulic leaks.
49).
Tilting the Seat (page 50).
(Figure 117).
2. Charge filter
Lowering the

Hydraulic Fluid Capacity

41.6 L (11 US gallons); refer to
Specification (page 71)
Changing the Hydraulic
Fluid
Service Interval: Every 2,000 hours—If you
Every 800 hours—If you are not using the
recommended hydraulic fluid or have ever
filled the reservoir with an alternative fluid,
change the hydraulic fluid.
If the fluid becomes contaminated, contact your Toro
Distributor because the system must be flushed.
Contaminated fluid looks milky or black when
compared to clean fluid.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Place a large drain pan under the manifold
(Figure 118) on the bottom the hydraulic tank;
refer to Hydraulic Fluid Capacity (page
g421602
1. Manifold
2. Loosen fitting here
3. Disconnect the 90° fitting from the manifold and
allow the tank to drain.
4. When hydraulic fluid stops draining from the
tank, connect the 90° fitting to the manifold.
73
Hydraulic Fluid
are using the recommended
hydraulic fluid, change the
hydraulic fluid.
49).
Figure 118
3. 90° fitting
73).
g421603