Toro Reelmaster 5010-H Operator's Manual page 14

1. Flange locknut (3/8 inch)
2. Right tab (Carrier frame)
5. Align the holes in the turf-compensator bracket
with the holes in the cutting-unit frame
14).
Note:
The support loop of the hose guide aligns
toward the centerline of the machine.
1. Turf-compensator bracket
2. Carriage bolt (3/8 x 1-1/4
inches)
6. Assemble the turf-compensator bracket to the
cutting-unit frame with the 2 carriage bolts (3/8 x
1-1/4 inches) and 2 flange locknuts (3/8 inch).
7. Torque the locknuts and bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
8. Repeat steps 1 through
unit.
Installing the Front Cutting Units
to the Lift Arms
1. Slide a cutting unit under the lift arm
Figure 13
3. Capscrew
Figure 14
3. Flange locknut (3/8 inch)
4. Inboard
7 for the other cutting
(Figure
g375694
1. Cap
2. Snapper pin
2. Assemble the pivot yoke onto the carrier frame
(Figure
shaft.
3. Assemble the cap to the pivot yoke, and align
the holes in the carrier frame shaft, pivot yoke,
and cap.
4. Secure the cap and the carrier-frame shaft to
the pivot yoke with the snapper pin.
5. Lock the cutting-unit pivot for cutting grass on a
hill side; refer to
for Cutting Grass on a Hill Side (page
Installing the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Higher Height of Cut
g378789
1. Slide a cutting unit under the lift arm
15).
14
Figure 15
3. Pivot yoke
4. Carrier frame shaft
Locking the Cutting-Unit Pivot
16).
(Figure
g375274
16).