6.
Repeat the procedure on the remaining 4
bulkhead locations as shown in
through
Figure
28.
Important:
The connector plates are
positioned differently at the remaining
locations so the hose can be routed through
the bulkhead bracket and to the cutting unit
without getting twisted or kinked.
Figure 25
Left rear cutting unit (#2)
1. Bulkhead bracket
2. Extra flange nut
Figure 26
Center front cutting unit (#1)
(Underside of machine shown)
1. Connector plate
2. Extra flange nut
Figure 25
g316994
3. Connector plate
g316976
3. Bulkhead bracket
Right front cutting unit location (#5)
1. Bulkhead bracket
2. Connector plate
Right rear cutting unit (#3)
1. Extra flange nut
2. Bulkhead bracket
18
Figure 27
3. Extra flange nut
Figure 28
3. Connector plate
g316996
g316998