Figure 70
1. Upper generator
cooling-air shroud
2. Driveshaft-brush seal
2.
Align the holes in the generator cooling-air
shrouds with the compression-limiting pins.
3.
Secure the halves of the generator cooling-air
shrouds and compression-limiting pins with the
4 flange-head capscrews and 4 flange locknuts
(Figure
71).
g378915
3. Flange (generator cover)
4. Lower generator
cooling-air shroud
1. Flange-head capscrew
2. Upper generator
cooling-air shroud
Jacking Point Locations
Note:
Support the machine with jack stands
whenever you work under the machine.
Use the following as machine-lift points:
51
Figure 71
3. Flange locknut
4. Lower generator
cooling-air shroud
g378913