Toro Reelmaster 5010-H Operator's Manual page 16

1. Lynch pin
2. Lift-arm shaft
7. Insert the pivot yoke into the lift arm, and secure
shaft to the arm with the lynch pin and washer.
8. Repeat steps 1 through
cutting unit.
Locking the Cutting-Unit Pivot for
Cutting Grass on a Hill Side
Lock the cutting-unit pivots to prevent the cutting units
from rotating downhill when cutting across the face of
a hill. Use the hole in the pivot yoke
the cutting unit. Use the slot for a steering cutting unit.
1. Snapper-pin positions
2. Hole (pivot yoke)
Installing the Cutting Unit Lift-Arm
Chains
Secure the lift-arm chain to the chain bracket with the
snapper pin (Figure 21).
Note:
Use the number of chain links described in the
cutting unit Operator's Manual.
Figure 19
3. Lift arm
4. Washer
7 for the other rear
(Figure
Figure 20
3. Slot (pivot yoke)
g375239
1. Lift-arm chain
2. Chain bracket
Assembling the Reel Motors to the
Cutting Units
1. Apply a coat of clean grease to the splines of the
reel-motor shaft.
2. Apply a coat of oil the reel motor O-ring and
install it onto the motor flange.
3. Align the motor to the cutting unit so that the
motor flanges clear the bolts clockwise
20) lock
22).
Important:
cable is not twisted, kinked, or at risk of
being pinched.
g375251
16
Figure 21
3. Snapper pin
Make sure that the reel-motor
g003948
(Figure