Toro Reelmaster 5010-H Operator's Manual page 46

Maintenance Service
Interval
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Every 250 hours
Every 400 hours
Every 800 hours
Every 1,000 hours
Every 2,000 hours
Before storage
Every 2 years
Maintenance Procedure
• Grease the bearings and bushings (and immediately after every washing).
• Clean the battery and check the condition of it (or weekly, whichever comes first).
• Check the battery-cable connections.
• Inspect the cooling system hoses.
• Check the condition and tension of the alternator belt.
• Change the engine oil and filter.
• Drain moisture from the fuel and hydraulic fluid tanks.
• Torque the wheel lug nuts to 94 to 122 N∙m (70 to 90 ft-lb).
• Service the air cleaner. (more frequently in extremely dirty or dusty conditions).
Service the air cleaner earlier if the air-cleaner indicator shows red.
• Replace the fuel/water separator filter.
• Replace the engine fuel filter.
• Inspect the fuel lines and connections.
• Check the blade-stop time.
• Check the engine speed (idle and full throttle).
• Drain and clean the fuel tank. Drain and clean the fuel tank if the fuel system
becomes contaminated.
• Check the rear wheel toe-in.
• If you are not using the recommended hydraulic fluid or have ever filled the reservoir
with an alternative fluid, replace the charge filter.
• If you are not using the recommended hydraulic fluid or have ever filled the reservoir
with an alternative fluid, change the hydraulic fluid.
• Pack the rear wheel bearings.
• Adjust the engine valves (refer to the engine service manual).
• If you are using the recommended hydraulic fluid, replace the charge filter.
• If you are using the recommended hydraulic fluid, change the hydraulic fluid.
• Drain and clean the fuel tank. Drain and clean the fuel tank if you store the machine
for an extended period.
• Flush and replace the cooling system fluid.
• Replace the hydraulic hoses.
• Replace the coolant hoses.
• Flush and replace the coolant.
• Replace all moving hoses.
46