Checking The Interlock Switches - Toro Reelmaster 7000-D Operator's Manual

Fuel (continued)
Adding Fuel
1. Park the machine on a level surface, lower the
cutting units, shut off the engine, and remove
the key.
2. Clean the area around the fuel-tank cap
and remove the cap.
3. Fill the tank until the level is to the bottom of
the filler neck
4. Install the fuel-tank cap tightly.
Note:
use. Filling the fuel tank minimizes
condensation inside the tank.

Checking the Interlock Switches

If safety interlock switches are disconnected or damaged, the machine could operate
unexpectedly, resulting in minor or moderate injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches daily and replace any damaged
switches before operating the machine.
If your machine fails any of the interlock switch checks, contact your authorized Toro
distributor.
Preparing the Machine
1. Drive the machine slowly to an open area.
2. Lower the cutting units, shut off the engine, and engage the parking brake.
Checking the Traction Pedal Start-Interlock
1. Sit in the operator's seat and engage the parking brake.
2. Press the PTO switch to the D
Operation: Before Operation
with the specified fuel.
If possible, fill the fuel tank after each
G423841
CAUTION
IMPORTANT
position.
ISENGAGE
Page 5–3 3466-706 A