Seat Controls - Toro Reelmaster 5010-H Operator's Manual

Note:
Ensure that you lower the cutting units after
the PTO switch has been engaged to start the cutting
units. When you lower the cutting units before the
PTO switch is engaged, they do not start spinning.
To fully raise the cutting units, pull the lever backward.
When the cutting units are raised and the PTO switch
is disengaged, the machine is in T
To partially raise the cutting units to the turnaround
position, briefly pull the lever backward.
InfoCenter
The InfoCenter LCD display shows information about
your machine, such as the operating status, various
diagnostics, and other information about the machine
(Figure 39).
The screens that display, depend on which buttons
you select. The purpose of each button may change
depending on what is required at the time.
Headlight Switch
Pivot the switch upward to turn on the headlights
(Figure 39).
Power Point
The power point is a 12 V power supply for electronic
devices (Figure 42).
Figure 42
1. Power point
Cutting-Unit-Power Disconnect
Before installing, removing, or working on the cutting
units, disconnect the cutting units from the power
supply by separating the cutting-unit-power-disconnect
connector (Figure 43), located under the seat. Plug
the connector back in before operating the machine.
mode.
RANSPORT
g419730
24
Figure 43
1. Power-disconnect connector
CAUTION
If you do not disconnect the power to the
cutting units, someone could accidentally
start the cutting unit, causing serious injury
to hands and feet.
Always separate the
cutting-unit-power-disconnect connector
before working on the cutting units.

Seat Controls

Figure 44
1. Weight gauge
2. Weight-adjusting knob
g027134
g419753
3. Height-adjusting knob
4. Seat-position lever