Using The Menus - Toro Reelmaster 5010-H Operator's Manual

Traction unit
Hide thumbs Also See for Reelmaster 5010-H:
Table of Contents

Advertisement

InfoCenter Icon Description (cont'd.)
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
Switch
Release the switch.
Change to the indicated state.
Warm-up mode
Symbols are often
combined to form
sentences. Some
examples are shown
below
Put the machine into Neutral.
Engine start is denied.
Engine shutdown
Engine coolant is too hot.
Sit down or set parking brake

Using the Menus

To access the InfoCenter menu system, press the
menu access button while at the main screen. This
brings you to the main menu. Refer to the following
tables for a synopsis of the options available from
the menus:
Main Menu
Menu Item
Faults
Description
The Faults menu contains a list
of the recent machine faults.
Refer to the Service Manual or
contact your authorized Toro
distributor for more information
on the Faults menu and the
information contained there.
Service
Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Cutting Units
Hi/Low Range
PTO
Engine Run
Backlap
Settings
Menu Item
Units
Language
29
The Service menu contains
information on the machine
such as hours of use, counters,
and other similar numbers.
The Diagnostics menu
displays the state of each
machine switch, sensor, and
control output. You can use
this to troubleshoot certain
issues as it quickly tells you
which machine controls are on
and which are off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description
Lists the total number of hours
that the machine, engine and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due.
Lists numerous counts the
machine has experienced.
Description
Indicates the inputs, qualifiers,
and outputs for raising and
lowering the cutting units.
Indicates the inputs, qualifiers,
and outputs for driving in
transport mode.
Indicates the inputs, qualifiers,
and outputs for enabling the
PTO circuit.
Indicates the inputs, qualifiers,
and outputs for starting the
engine.
Indicates the inputs, qualifiers
and outputs for operating the
backlap function.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric.
Controls the language used
on the InfoCenter*.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

03950

Table of Contents