Protected Menus - Toro Reelmaster 5010-H Operator's Manual

LCD Backlight
LCD Contrast
Front Backlap Reel Speed
Rear Backlap Reel Speed
Blade Count
Mow Speed
Height of cut (HOC)
F Reel RPM
R Reel RPM

Protected Menus

Protect Settings
Acceleration
Mow Speed
Trans. Speed
Smart Power
Turnaround
Economy Mode
Clip Control
*Only "operator-faced" text is translated. Faults,
Service, and Diagnostics screens are "service-faced."
Titles are in the selected language, but menu items
are in English.
Protected under Protected Menus—accessible only
by entering PIN
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Controls the speed of the front
reels in backlap mode.
Controls the speed of the rear
reels in backlap mode.
Controls the number of blades
on the reel for reel speed.
Controls the ground speed for
determining the reel speed.
Controls the height of cut
(HOC) for determining the reel
speed.
Displays the calculated reel
speed position for the front
reels. The reels can also be
manually adjusted.
Displays the calculated reel
speed position for the rear
reels. The reels can also be
manually adjusted.
Allows a person
(superintendent/mechanic)
authorized by your company
with the PIN code to access
protected menus.
Allows the ability to change
the settings in the protected
settings
Low, Medium, and High
settings control how quickly
the traction speed reacts when
you move the traction pedal.
Controls the maximum speed
while in mow (low range)
Controls the maximum speed
while in transport (high range)
Turns Smart Power on and off
Turns Turnaround on and off
When activated, the Economy
Mode lowers the engine
speed while mowing to reduce
noise and fuel consumption.
The reel speed does not
change, but the mow speed is
decreased if the mow stop is
not adjusted accordingly.
Turns Clip Control on and off
About
Menu Item
Model
SN
Machine Controller Revision
CU 1
CU 2
CU 3
CU 4
CU 5
Generator
InfoCenter Revision
CAN Bus
Protected Menus
There are operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter.
To lock these settings, use the Protected Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
30
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the primary controller.
Lists the software revision of
each cutting unit.
Lists the software revision of
the motor/generator.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
M , use the center button to
ENU
M and press the
ETTINGS ENU
47).
Figure 47
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 48A).
g028523