Toro Reelmaster 5010-H Operator's Manual page 23

1. Traction pedal
Traction Pedal
The traction pedal (Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move backward. Ground
speed depends on how far you press the pedal.
To achieve maximum ground speed, set the maximum
ground speed and press the pedal forward while in
transport mode.
To stop the machine, reduce foot pressure on the
traction pedal and allow it to return to the center
(neutral) position.
Note:
The machine will return to neutral quickly when
you remove your foot from the traction pedal.
Engine-Speed Switch
The engine-speed switch
change the engine speed. By momentarily tapping the
switch, you can change the engine speed in 100 rpm
increments. If you hold the switch down, the engine
automatically moves to High or Low idle, depending
on which end of the switch you press.
Cruise-Control Switch
The cruise-control switch has 3 positions: O
and E .
NGAGE
To turn on the cruise control, pivot the switch to the
middle position.
To engage the cruise control, briefly pivot the switch
forward. When cruise control is engaged, the cruise
control screen will appear on the InfoCenter. Use the
InfoCenter buttons to adjust the cruise control speed
in 0.8 km/h (0.5 mph) increments.
Tilt-Steering Pedal
To tilt the steering wheel toward you, press the
tilt-steering foot pedal
Figure 40
2. Tilt-steering pedal
40) controls the forward and
(Figure 39) has 2 modes to
(Figure 40) down, pull the
steering tower toward you to the most comfortable
position, and release the pedal.
Key Switch
The key switch
O /P
N REHEAT
Power-takeoff (PTO) Switch
When the PTO switch is engaged, the machine is in
g383839
M mode, which allows you to drive up to 13 km/h
OW
(8 mph) when the maximum speed is not limited.
When the PTO switch is not engaged
machine is in T
to drive up to 16 km/h (10 mph) when the maximum
speed is not limited.
Note:
Use the protected menus in the InfoCenter to
set the maximum speed for each mode.
1. Disengaged
Parking Brake
To engage the parking brake,
switch forward on the console. The red light on the
switch turns on when it is set. To release the parking
brake, pivot the switch backward.
Activating the parking-brake switch causes the traction
to automatically decelerate, regardless of traction
, O , pedal position, and engage the parking brake as soon
FF N
as the machine comes to a stop.
Once the engine has been shut off and the machine is
not moving, the parking brake engages, regardless of
parking-brake switch position.
Lower Mow/Raise Control Lever
This lever
units.
To lower the cutting units, push the lever forward.
When the PTO switch is E
M mode, and the cutting units will start spinning
OW
when lowered.
23
(Figure 39) has 3 positions: O
, and S .
TART
mode, which allows you
RANSPORT
Figure 41
2. Engaged
(Figure
(Figure 39) raises and lowers the cutting
NGAGED
,
FF
(Figure 41), the
g424477
39) pivot the
, the machine is in