Protected Menus - Toro Groundsmaster 4500-D Operator's Manual

Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Left Cutting Unit
Center Cutting Unit
Right Cutting Unit
Traction
HI/LO Range
PTO
Engine
Cruise
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast

Protected Menus

Protect Settings
Acceleration
Mow Speed
Trans. Speed
Smart Power
Description
Lists the total number of hours
that the machine, engine, and
fan have been on, as well
as the number of hours the
machine has been transported
and overheated
Lists the number of starts,
cutting unit/PTO cycles, and
fan reversals the machine has
experienced
Description
Refer to the Service Manual
or your authorized Toro
distributor for more information
on the Engine Run menu and
the information contained
there.
Description
Controls the units used on the
InfoCenter (English or Metric)
Controls the language used
on the InfoCenter*
Controls the brightness of the
LCD display
Controls the contrast of the
LCD display
Allows a person authorized
by your company with the
PIN code to access protected
menus.
Allows the ability to change
the settings in the protected
settings
Low, Medium, and High
settings control how quickly
the traction speed reacts when
you move the traction pedal.
Controls the maximum speed
while in mow (low range)
Controls the maximum speed
while in transport (high range)
Turns Smart Power on and off
Counterbalance
Turnaround
*Only operator-faced text is translated. Faults,
Service, and Diagnostics screens are service-faced.
Titles are in the selected language, but menu items
are in English.
Protected under Protected Menus—accessible only
by entering PIN
About
Menu Item
Model
SN
S/W Rev
Protected Menus
There are 6 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
auto idle, maximum mowing ground speed, maximum
transport ground speed, Smart Power, cutting unit
counterbalance, and Turnaround. These settings are
in the Protected Menu.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
29
Controls the amount of
counterbalance applied by the
cutting units
Turns Turnaround on and off
Description
Lists the model number of the
machine
Lists the serial number of the
machine
Lists the software revision of
the master controller
M , use the center button to
ENU
M and press the
ETTINGS ENU
23).
Figure 23
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 24A).
g028523