Seat Width Reducing Padding; Positioning Kit - Otto Bock KIWI Instructions For Use Manual

7.3 Seat Width Reducing Padding (Fig. 41)
Seat width reducing padding can be used to reduce the seat width size 1.
Open the lateral snap fasteners of the seat padding and slide the seat width reducing padding
onto the lateral flaps of the seat padding (Fig. 41).
After sliding on the seat width reducing padding, the opening in the seat width reduc-
INFORmATION
ing padding must be located over the snap fastener of the seat padding (Fig. 41, arrow).
Finally reattach the seat padding with the snap fasteners.
7.4 Positioning Kit (Fig. 42-44)
Additional pads can be used to provide more support to the child's trunk. The child may remain
seated in the seat while adding the pads.
Open the zippers on the rear side of the back padding cover (Fig. 42).
Attach the pads (equipped with hook patches) into the back padding in the desired position
(Fig. 43).
For secure hold of the additional pads, slide the supplied back plate into the back padding cover
(Fig. 44). Close the zippers.
46
39
41
40