Dalsa PC-30-02K80-R Manual page 68

Piranha Color Camera User's Manual
Syntax
get sao
get sbr
get scb
get scc
get scd
get scl
get sdo
get sem
get set
get sfc
get sfr
get sil
get slt
get smm
get sot
get spc
get spr
get ssb
get ssf
DALSA
Parameters Description
t Returns the analog offset for the tap indicated.
t = 0 for all taps or 1 to 4 for individual tap selection.
Returns the speed of camera serial communication port.
Returns cable parameter.
Returns current color correction coefficients.
Returns the CCD shift direction selection where:
0 = Forward CCD shift direction.
1 = Reverse CCD shift direction.
2 = Externally controlled direction control via CC3.
Return current color selection (rgb, r, g, or b)
t Returns the digital offset value in DN for the tap
indicated.
t = Tap value. 0 for all taps or 1 to 2 for individual tap
selection.
Returns the current exposure mode:
2 = Internal SYNC, internal PRIN, programmable line
rate and exposure time using commands ssf and set
3 = External SYNC, maximum exposure time
4 = Smart EXSYNC
5 = External SYNC and PRIN
6 = External SYNC, internal PRIN, programmable
exposure time
7 = Internal programmable SYNC, maximum
exposure time.
Returns the current exposure time in µs.
x Returns the FPN coefficient for the pixel number
indicated.
x =pixel number within the range 1 to n, where n =
2048 or 4096 depending on the resolution.
x1 x2 Returns pixel range of FPN coefficients. x1 < x2.
t a Returns single LUT entry.
Only available when a single color is selected.
t = tap: 1 to 4
a = LUT address
Returns the current lower threshold value. This
command depends on the color selected previously
using the scl command.
Returns mirroring mode:
0: Off
1: On
Returns output throughput in mega pixels per second
(mps) per color.
x Returns the PRNU coefficient for the specified pixel
number.
This command is only available when a single color is
selected.
x=pixel number within the range 1 to n, where n =
2048 or 4096 depending on the resolution.
x1 x2 Returns the pixel range of PRNU coefficients. x1 < x2.
t Returns the current background subtract value.
t = Tap value. 0 for all taps or 1 to 4 for individual tap
selection depending on camera model.
Returns the current line rate in Hz. Only available while
03-032-10211-03
68
9/27/2007