Dalsa PC-30-02K80-R Manual page 87

Piranha Color Camera User's Manual
Mnemonic
set sync frequency
set system gain
set select number
set upper threshold
set video mode
update gain reference
verify temperature
verify voltage
write FPN coefficients
write input LUT
write PRNU coeffs
DALSA
Syntax Parameters
ssf f
ssg t i
ssn i
sut i
svm i
ugr
vt
vv
wfc
wil
wpc
03-032-10211-03
Description
t = Tap value. 0 for all taps or 1 to
number of camera taps the color
selected.
i = Subtracted value in a range from 0
to 4095.
Set internal line rate. 1Hz to 22,714
Hz (2k model) or 12,132 Hz (4k
model).
Set the digital gain.
t = tap selection, 0 for all taps or 1 to
number of camera taps for color
i = Digital gain in a range from 0 to
65,535. The digital video values are
multiplied by this number divided by
4,096.
Set number for write/load settings
commands:
0 = Factory set (load only)
1-4 = Internal user sets
The pixels equal to or greater than the
upper threshold are counted and
reported in the end-of-line sequence.
i = Threshold 0-4095.
Switch between normal video mode
and camera test patterns:
0: Normal video
1: Horizontal ramp
2: Diagonal ramp
3: Vertical ramp
4: N/A - A5 pattern
5: N/A - Data transmission
6: DC value
7: FPN demo
8: PRNU demo
9: All 4095 (to get FPN)
10: All 2048 (to get PRNU)
11: Power toggle
12: All 320 - FPN offset
13: All zeros
14: All ones
For all taps, changes 0 dB gain to equal
the current analog gain value.
Display the internal temperature of the
camera.
Display the voltage supplied to the
camera.
Write current FPN coefficients to non-
volatile memory set previously using
the ssn command.
Write current LUT's to non-volatile
memory set previously using the ssn
command.
Write current PRNU coefficients to
87
9/27/2007