Dalsa PC-30-02K80-R Manual page 30

Piranha Color Camera User's Manual
Note:
Example:
Color selection limits the taps that can be selected in these commands as follows:
scl
rgb
r
g
b
Selecting the Set Number
Purpose:
Syntax:
Syntax Elements:
Note:
Related Commands
Example:
Setting a Region of Interest (ROI)
Purpose:
Syntax:
Syntax Elements:
Notes:
Related Commands
DALSA
g = adjust green
b = adjust blue
The camera always powers up using scl rgb.
scl b
Tap Notes
0 All 10 camera taps
0 All 4 red taps
1 to 4 Single red tap
0 All green taps
1 to 4 Single green tap
0 All blue taps (2)
1 to 2 Single blue tap
When saving and loading camera settings, you have a choice of
saving up to four different sets and loading from five different
sets (four user and one factory). This command determines the
set number from where these values are loaded and saved. The
set number is saved along with the camera settings when the
wus command is issued.
ssn i
i
0 = Factory set. Settings can only be loaded from this set.
1 - 4 = User sets. You can save, or load settings with these
sets.
The camera powers up with the last set saved using this
command.
wus, lus, wil, lil, wfc, lfc
ssn 3
Sets the pixel range used to collect the end-of-line statistics and
sets the region of pixels used in the ccg, gl, gla, ccf, and
ccp commands.
In most applications, the field of view exceeds the required object
size and these extraneous areas should be ignored. It is
recommended that you set the region of interest a few pixels
inside the actual useable image.
roi x1 x2
x1
Column start number. Must be less than the pixel end number
in a range from 1 to sensor resolution.
x2
Column end. Must be greater than the pixel start number in a
range from 1 to sensor resolution.
To return the current region of interest, use the commands gcp
or get roi.
ccg, gl, gla, ccf, ccp, cpa, els
03-032-10211-03
30
9/27/2007