Removing The Clutch Hub And The Clutch Basket; Reassembling The Clutch Hub Components - SHERCO 250 SEF-R Workshop Manual

Removing the clutch hub and the
clutch basket
 Drain the engine oil and the engine coolant.
 Remove
the
disassembling the right side paragraph)
 Remove the clutch. (see clutch removal
paragraph)
 Remove the clutch release bearing assembly.
 Retain the clutch hub using tool 1814.
 Loosen the clutch hub nut.
ATTENTION : make sure the special timing
tool number 1819 is not installed, if it is,
severe damage could occur to the crankshaft
and crankcase.
 Remove the hub and the nut.
 Inspect the needle bearings and replace if
necessary.
 Visually inspect the hub and the housing.
Reassembling
components
 Install the thrust washer.
 Install the needle bearings.
 Install the clutch housing.
ATTENTION : The clutch basket wheel is
appeared with the primary gear.
 Install the spacer washer.
 Install the clutch hub.
 Install the special washer.
 Grease the threads of the shaft and the nut.
 Apply thread locker (blue) to the nut thread.
 Install the fixing nut
Torque the fixing nut to: 80Nm.
 Check for free rotation of the clutch hub.
 Blend the special washer over the nut.
 Install the seat, judder spring.
clutch housing.
the clutch
(see
hub
24