Assembling The Crankcase Halves - SHERCO 250 SE-R 2017 Workshop Manual

REASSEMBLY THE ENGINE
❱❘ Assembling the crankcase halves
- Install the transmission lubrification tube in the
right crankcase half.
CAUTION
Install the tube with the flat side towards
the oil filler cap rivet. Install the O-ring on the
transmission lubrication tube.
- Make sure the locating dowels are in place in
the RH case and that the shim washers are
installed on the transmission shafts.
- Apply a light coat of grease on a new gasket
and install it on the RH case.
- Grease the seals in the LH case and then
carefully install it.
- Install the screws and tighten them to 10 Nm.
- Tap on the end of the crankshaft with a plastic
mallet and then make sure the transmission
gears turn freely.
55
55
55
55
70
55
M6X...
55
55
45
45
45
45
37