Quick Start Guide; Apply Power To The Controller; Wiring For The Dxmr110-8K - Banner DXMR110-8K Instruction Manual

3. Quick Start Guide

3.1. Apply Power to the Controller

Follow these instructions to apply 12–30 V DC power to the DXMR110-8K using a wall plug.
P :
REREQUISITE
Required equipment:
• DXMR110-8K IO-Link Master
• PSW-24-1 Wall plug power supply; 24 V DC, 1 A (or equivalent 24 V DC M12 power supply)
1. Connect the PSW-24-1 power supply to the male M12 connector on the DXMR110-8K, Port 0.
Plug in the PSW-24-1 wall plug power supply.
2.

3.1.1. Wiring for the DXMR110-8K

Device LEDs (x16)
M12 Power Port
(Male)
M12 Power Port
(Female)
Table 1: Ports 1-8 female connector
Port 1–8 5-pin M12 Connector (female)
2
1
3
4 5
Table 2: 4-pin M12 male connector
4-pin M12 Power Connector (male)
1
2
4
3
IO-Link Master Ports 5-8
(Female)
IO-Link Master Ports 1-4
(Female)
Figure 1: DXMR110-8K IO-Link Master ports
Pin Wire Color
1 Brown (bn) 18 V DC to 30 V DC
2 White (wh) I/Q (digital in-out)
3 Blue (bu) DC common (GND)
4 Black (bk) C/Q (communications/digital in-out)
5 Gray (gy) Not used/reserved
Pin Wire Color
1 Brown (bn) 18 V DC to 30 V DC
2 White (wh) 18 V DC to 30 V DC
3 Blue (bu) DC common (GND)
4 Black (bk) DC common (GND)
© Banner Engineering Corp. www.bannerengineering.com
D-Coded Ethernet
(Female)
D-Coded Ethernet
(Female)
Description
Description
Q S G
UICK TART UIDE
6