Save And Upload The Configuration File; Installing The Dxmr110-8K - Banner DXMR110-8K Instruction Manual

Io-link master

Table of Contents

UICK

TART

UIDE

3.2.2.3. Save and Upload the Configuration File

After making any changes to the configuration, you must save the configuration files to your computer, then upload it to the device.

ONTEXT

Changes to the XML file are not automatically saved. Save your configuration file before exiting the tool and before sending the XML file to the

device to avoid losing data. If you select DXM > Send XML Configuration to DXM before saving the configuration file, the software will prompt

you to choose between saving the file or continuing without saving the file.

Save the XML configuration file to your hard drive by going to the File > Save As menu.

Go to the DXM > Send XML Configuration to DXM menu.

•

If the Application Status indicator is red, close and restart the DXM Configuration Tool, unplug and re-plug in the cable and recon-

nect the DXM to the software.

•

If the Application Status indicator is green, the file upload is complete.

•

If the Application Status indicator is gray and the green status bar is in motion, the file transfer is in progress.

After the file transfer is complete, the device reboots and begins running the new configuration.

TEP

ESULT

Install the DXMR110-8K to allow access for functional checks, maintenance, and service or replacement.

Fasteners must be of sufficient strength to guard against breakage. The use of permanent fasteners or locking hardware is recommended to

prevent the loosening or displacement of the device. The mounting hole (4.5 mm) in the DXMR110-8K accepts M4 (#8) hardware. See the figure

below to help in determining the minimum screw length.

Screw Length = 16.0 mm + "X" mm + 3 mm

: Do not overtighten the DXMR110-8K's mounting screw during installation. Overtightening can affect the performance of the

CAUTION

DXMR110-8K.

Figure 6: Status indicator bar

NUT

16.0 mm

3 mm *

for minimum

engagement of

three threads

Table of Contents