Table of Contents
Advertisement
•
Modbus/TCP Controller/Primary Read or Write rules for external devices on the network
Wired Connectivity
Ethernet: Modbus/TCP (client/server), Ethernet/IP, or PROFINET
User Interface
API Interface—Host Initiated control and Web service integration
2.1. DXMR110-8K Models
Model
Two female M12 D-Code Ethernet
Connectors for daisy chaining and
DXMR110-8K
communication to a higher-level control
system
2.2. Automation Protocols for the DXMR110-8K
The DXMR110-8K IO-Link Master supports the following automation protocols.
EtherNet/IP
By default, EtherNet/IP is enabled. Configure the DXMR110-8K Local Registers as EtherNet/IP input or output registers using the DXM Configuration Software.
A single register can only be set as either an EtherNet/IP input or output register.
EtherNet/IP registers are limited to 228 read registers set as E/IP Originator to DXM and 228 write registers set as DXM to Originator
Modbus TCP/IP
A host system acting as a Modbus master (Client) can access the DXMR110-8K using the Modbus TCP/IP protocol over Ethernet. Standard Modbus TCP port
502 is used by the DXMR110-8K for all Modbus TCP/IP requests.
All internal local registers are available to the host system concurrently with Modbus TCP.
By default, the DXMR110-8K is configured as a Modbus TCP/IP Server.
PROFINET
By default, PROFINET is disabled on the DXMR110-8K. To enable and configure the DXMR110-8K for PROFINET communications, use the DXM Configuration
Software.
The DXMR110-8K uses fixed slot sizes and locations in the Local Registers for the input and output values. Supported module sizes are 64, 128, 256, and 512
bytes, which range from 32 to 256 in the DXMR110-8K's Local Registers.
2.3. DXMR110-8K Dimensions
All measurements are listed in millimeters, unless noted otherwise.
Ethernet Connection
Eight female M12 connections for
IO-Link master connections
© Banner Engineering Corp. www.bannerengineering.com
IO-Link Master Connections
DXMR110-8K O
Other Connections
One male M12 for incoming power, one female M12
for daisy chaining power
VERVIEW
4
Advertisement
Table of Contents
