Chapter 5
5. Under Filter Type, select Moving Average if you want to filter the data or Raw if you do not
6. Under Log Channels to Disk, check the channels that you want to log to disk when you
7. Under External Trigger Enable, select True if you want to start acquisition using an
8. Under Channel Names, specify a meaningful name to represent each channel.
9. Under Acquisition Frequency, click the frequency (10 Hz, 5 Hz, 2 Hz, Every 2 s, Every 5 s,
10. When you are finished configuring the Measurement Application, click OK.
11. To save the configuration settings, click the Configuration menu, and then click Save
12. Enter a name for the configuration file, select the directory in which to save the file, and
13. Restart acquisition by clicking Start Acquisition from the Acquisition menu or by
68
Note: If you want to set all the channels to the same configuration at once, select the
configuration to apply using the Set all to combo box.
If you select a voltage sensor type for a channel, the data is displayed in voltage. The
sensor type setting is ignored for the digital input port.
want to filter the data.
use the Chart Recorder (described on
Application, all channels are selected for data logging.
external trigger signal connected to digital input line 0; otherwise, select False.
Every 10 s, Every Minute, Every 2 Minutes, Every 5 Minutes) at which to simultaneously
sample all channels.
Configuration File.
then click Save.
This file has the extension (*.Measurement).
Note: You can save numerous configuration settings, if desired. To load a previously
saved configuration, click the Configuration menu, and then click Load Configuration
File.
clicking Start/Stop from the main window.
page
71). The first time you use the Measurement