Table of Contents
Advertisement
Applying Power
TEMPpoint, VOLTpoint, and MEASURpoint instruments are shipped with an EP361 +5V
power supply and cable. To apply power to the instrument, do the following:
1. Connect the +5 V power supply to the power connector on the rear panel of the
instrument. Refer to
To wall
outlet
Figure 2: Attaching a +5 V Power Supply to the Instrument
2. Plug the power supply into a wall outlet.
IMPORTANT: For proper grounding of your measurement instrument, ensure that you
use the power supply and cable (EP361) that is provided with the instrument and that you
use all three prongs of the cable when connecting it to your wall outlet.
3. Press the Power Switch to turn on the instrument.
The Power LED on the front panel lights to indicate that power is on.
Figure 3
shows the front panel of the instrument, including the location of the Power LED.
Figure
2.
Instrument Rear Panel
Digital I/O
USB
EP361 +5 V
Power Supply
Setting Up and Installing the Instrument
Power
5 V In
Switch
31
Advertisement
Table of Contents
