Running The Measurement Application - Data Translation TEMPpoint DT9871U User Manual

Chapter 5

Running the Measurement Application

To run the Measurement Application, perform the following steps:
1. Click Start -> Programs -> Data Translation, Inc -> Measurement -> Measurement
2. By default, the application "discovers" all TEMPpoint, VOLTpoint, and MEASURpoint
3. If your instrument is included in the list of Available Instruments and you want to
4. If you do not have a TEMPpoint, VOLTpoint, or MEASURpoint instrument connected or
64
Application
The Device Selection screen is displayed:
instruments that are available and displays them in the list of Available Instruments. If
you want to refresh this list to determine if other TEMPpoint, VOLTpoint, or
MEASURpoint instruments are available, click Refresh list.
connect to it, select the connect string for the instrument that you want to use from the list
of Available Instruments, and then go to step 6.
Information about the instrument, including the scanning status, model number, firmware
version, and serial number, is displayed.
if you want to simulate the operation of an instrument, click one of the following
selections, and then go to step 6:
− Device Simulation Mode - MEASURpoint – Simulates the operation of a
MEASURpoint instrument.
− Device Simulation Mode - VOLTpoint – Simulates the operation of a VOLTpoint
instrument.