Table of Contents
Advertisement
Overview
You can verify the operation of your TEMPpoint, VOLTpoint, or MEASURpoint instrument
using the Measurement Application that is provided with the instrument. The Measurement
Application, developed using Measure Foundry, lets you perform the following functions:
• Configure your instrument
• Acquire temperature, resistance, and/or voltage data from up to 48 analog input channels
• Display temperature, resistance, and/or voltage data during acquisition
• Use a Chart Recorder to display and log data to an.hpf file for later analysis
• View any .hpf file, and view the last recorded .hpf data file in Microsoft Excel®
• Set minimum and maximum alarm limits for each channel
• Set the state of the digital output lines based on alarm limits
• Read the state of the digital input port
If desired, you can use Measure Foundry to customize this application.
Refer to
page 27
for information on installing the Measurement Application.
Verifying the Operation of Your Instrument
63
Advertisement
Table of Contents
