Co Concentration According To Pettenkofer Limit; Connection Of Supply And Exhaust Air Dampers (Version 1.1 / 1.2); Outside Air Dampers (Version S300); Connection Of Remote Control Panel, Knx Room Sensors And Modbus (Version S300) - Salda SMARTY XP Mounting And Installation Instruction
Source: salda.lt/en, vetter-lufttechnik.de
Hide thumbs
Also See for SMARTY XP:
- Mounting and installation instruction (48 pages) ,
- Mounting and installation instruction (60 pages)
Table of Contents
Advertisement
8.6.
CO
CONCENTRATION ACCORDING TO PETTENKOFER LIMIT
2
8.7.
CONNECTION OF SUPPLY AND EXHAUST AIR DAMPERS (VERSION 1.1 / 1.2)
Installation diagram
See "PIPING AND INSTRUMENTATION DIAGRAM".
Wiring diagram
Automation controller D zone. Upon activation of output X13:3, the dampers open. Upon activation of output X13:4, the dampers close.
8.8.
OUTSIDE AIR DAMPERS (VERSION S300)
output Q34 (T14:1), dampers shall open. Upon deactivation of output, dampers shall close. When activated, 230V voltage is applied to Q34 output.
WARNING: High voltage on output.
8.9.
CONNECTION OF REMOTE CONTROL PANEL, KNX ROOM SENSORS AND MODBUS
(VERSION S300)
SMARTY v2023.1
Figure 8.8.1.
Connection for outside dampers
EN |
39
Advertisement
Table of Contents
