10.6. ALARM INDICATION OUTPUT
triggered only B type alarm, only:
• In CONFIGURATION
• Change Y1
A - ALARM INDICATION OUTPUT, B - ALARM INDICATION OUTPUT (depending on preferred indication function).
• Press APPLY – RESTART DEVICE
10.7. REMOTE CONTROLLER AND KNX ROOM SENSORS
• In CONFIGURATION
• Set SELECTION FOR ROOM OPERATOR UNIT POS8
• Set SELECTION FOR ROOM SENSOR QMX3.P30 as ACTIVE.
• Set SELECTION FOR ROOM SENSOR QMX3.P40 as ACTIVE.
• Set SELECTION FOR ROOM SENSOR QMX3.P70 as ACTIVE.
• Press APPLY – RESTART DEVICE
11. OPERATING THE UNIT
• AUTO
user.
• MANUAL
• TEMPORARY
• COMFORT
• ECONOMY
• UNOCCUPIED
• PROTECTION
"APPLICATION FUNCTIONALITIES". Follow the link on the last page of this document.
START".
12. POSSIBLE FAULTS AND TROUBLESHOOTING
FAILURE
Unit is not operating
Air supply heater or pre-heater is not operat-
ing or malfunctioning (if installed)
on the remote control panel
52
| EN
ONLINE CONFIGURATION EXTENDED and press OK
ONLINE CONFIGURATION BASIC and press OK
MANUAL control mode:
CAUSE
No supply voltage
leakage relay is active (if installed by the
installer)
matic protection
Manual safety device is activated
broken, or its pressure is set improperly.
POS8.4420 or POS8.4440 (depending on remote controller type).
EXPLANATION / CORRECTIVE ACTIONS
-
Check if fans are rotating
MUST be contacted to identify and eliminate
the failure .
Filter replacement needed
DONE.
DONE.
OPERATIONS PRIOR FIRST
-
SMARTY v2023.1