When using the supply air heater, the supply air sensor (TJ) must be installed downstream the heater (or cooler) at the length
8.1.3. VERSION S300
SMARTY air handling units are able to control one heater or preheater coil at a time. When the preheater is used, one more temperature sensor
(VERSION S300)".
8.1.3.1. HEATER
1. Electric heating coil command;
2. Heating coil overtemperature detector;
3. Heating coil position signal.
NOTE: Power supply for the heater is not shown.
Heater Installation Diagram
When using the supply air heater, the supply air sensor (TJ) must be installed downstream the heater (or cooler) at the length
8.1.3.2. PREHEATER
1. Electric preheating coil command;
2. Air temperature after preheating coil;
3. Preheating coil overtemperature detector;
4. Preheating coil position signal.
36
| EN
KE
TJ
Mini MCB
Figure 8.1.3.1.1.
KE
1
TJ
Mini MCB
Siemens S300
TJ
Signals for electrical heater
ELECTRIC HEATER > SUPPLY AIR SENSOR (TJ).
TJ
EKA
"ACCESSORIES SETUP
KE1
SMARTY v2023.1
-