SOLTEK NF4-754RL Manual page 54

SL-NF4-754RL
x RxD , TxD Active The option controls the speed between receiving and
x IR Transmission
x UR2 Duplex Mode This options controls the operating mode between
x Use IR Pins When UART Mode is selected in IrDA or ASKIR
Onboard Parallel Port This item allows you to determine onboard parallel
Parallel Port Mode Select an operating mode for the on-board parallel
x EPP Mode Select Select EPP Mode when you choose EPP or
x ECP mode Use DMA Select a DMA channel for the port when you choose
PWRON After PWR-
transmitting of IrDA or ASKIR when using.
Choices: Hi,Hi; Hi,Lo; Lo,Hi; Lo,Lo
When UART Mode is selected in IrDA or ASKIR
Delay mode, it allows you to enable / disable IR Transmis-
sion Delay.
receiving and transmitting of IrDA or ASKIR. The
operating mode will be synchronous bi-directional
transmission and reception when Full mode is
selected. Nevertheless, the operating mode will be
asynchronous bi-directional transmission and recep-
tion when Half mode is selected.
The choices: Half; Full
mode, select the IR Pins signal selection.
The choices: IR-Rx2Tx2; RxD2, TxD2
port controller I/O address setting.
The choices: 378H/IRQ7; 278H/IRQ5; 3BC/IRQ7;
(printer) port. Select Normal, Compatible, or SPP
unless you are sure your hardware and software
both support one of the other available modes.
Choices: SPP; EPP; ECP; ECP+EPP; Normal
ECP+EPP mode in the Parallel Port Mode.
Choices: EPP1.7; EPP1.9
ECP or ECP+EPP mode for the Parallel Port Mode.
Choices: 1; 3
This item is to set the mode to power on when power
Fail resumes after power fails.
Choices: Off; On
Disabled
57
Chapter 4 BIOS Setup