SOLTEK NF4-754RL Manual page 53

SL-NF4-754RL
MAC Media Interface This option allows you to MAC Media interface.
IDE HDD Block Mode Block mode is also called block transfer, multiple
POWER ON Function Allows you to set the way to boot up the system.
x KB Power On Pass-
x Hot Key Power ON Allows you to set the hot key to boot up the system.
Onboard FDC
Controller
Onboard Serial
Port 1 / Port 2
UART Mode Select The serial port 2 on your system may offer a va-
The choices: Pin Strap; MII; RGMII
commands, or multiple sector read/write. If your IDE
hard drive supports block mode (most new drives
do), select Enabled for automatic detection of the
optimal number of block read/write per sector the
drive can support.
Choices: Enabled; Disabled
Choices: Password; Hot KEY; Mouse Left; Mouse
Right; Any KEY; BUTTON ONLY; Keyboard 98
If Keyboard Power-on function is set at "Password",
word this item shows up to allow you to type a password
for the power-On function.
Choices: N/A; Password
Select Enabled if your system has a floppy drive
controller (FDC) installing in the system board and
you want to use it. If you install add-in FDC or the
system has no floppy drive, select Disabled.
The choices: Enabled; Disabled
Select a logical COM port name and matching
address for the first and second serial ports.
Select an address and corresponding interrupt
for the first and second serial ports.
Choices: Disabled; Auto;
riety of infrared port modes. Click here for a de-
scription of various modes.
The choices: Normal; IrDA; ASKIR
3F8/IRQ4; 2F8/IRQ3;
3E8/IRQ4; 2E8/IRQ3
56
Chapter 4 BIOS Setup