Setting; Control Panel - WESTECH Solax X3-HYBRID G4 Manual

Firmware Upgrading
Step 5. For DSP: Please wait for 10 seconds. When "Update" page shown
as below, press down to select "DSP" and then press Enter. Please confirm
the firmware version again and press Enter to upgrade. The upgrade
takes about 2 minutes.
Update Update(DSP)
ARM >618.00360.00_Hybrid_
X3G4_DSP_V1.01_07
>DSP
10.usb
( f )
Update(DSP)
Upgrading---------25%
DSP Erasing---------
(i)
Step 6. After the upgrade is completed, the LCD screen displays" Upgrade
Successful" .
Upgrade Successful
Step 7. Plug off the U disk, press "Esc" to return to the main interface, and
long press the enter key to exit the mode.
Caution!
- Please strictly follow each step from step 1-6, don't
miss it.
- Please confirm the ARM/DSP firmware version on the
USB flash drive.
Tip: If the display screen is stuck on "X3-Hybrid G4" after the upgrade,
please turn off the photovoltaic power supply and restart, and the inverter
will restart and return to normal. If not,
please contact our service @solaxpower. com for help.
82
Update(DSP)
connect
(g) (h)
Update(DSP)
(j)
Upgrade(DSP)
(k)

7 Setting

7.1 Control Panel

Description
Name
LCD
Display inverter information on the LCD display.
Screen
Blue light: The inverter is in normal state or EPS(Off-grid) mode.
Blue ashing: The inverter is in the waiting, checking state
or the system switch is off.
Off: The inverter is in a fault state.
Green: The battery communication is normal but the battery
LED
MCB is disconnected, and the battery communication is
Indicator
normal and working normally.
light
Green ashing: The battery communication is normal and
in an idle state.
Off: The battery does not communicate with the inverter.
Red light on: The inverter is in a fault state.
Off: The inverter has no error.
ESC button: Return from the current interface or function.
Up button: Move the cursor to the upper part or increase the
Key
value.
Function
Down button: Move the cursor down or decrease the value.
Enter button: Con rm selection.
Setting
83