Installation Precautions; Tool Preparation - WESTECH Solax X3-HYBRID G4 Manual

Installation

4.3 Installation Precautions

The protection level of X3-Hybrid G4 series inverter is IP 65, so that the
inverter can be installed outdoors.
Check the installation environment and pay attention to the following
conditions when installing:
• Do not expose to strong light.
• Do not touch flammable building materials.
• Do not approach flammable and explosive gases or liquids (e.g. where
chemicals are stored).
• Do not touch cold air directly.
• Do not approach TV antenna or cable.
• Do not place in areas above 3000 meters above sea level.
• Do not install in precipitation or high humidity, which may cause
corrosion or damage Internal devices.
• Keep the system out of reach of children.
If the inverter is installed in a narrow area, be sure to reserve appropriate
space for heat dissipation.
The ambient temperature of the installation site is -35 ~60 .
The maximum angle range of wall tilt ±5°.
Avoid direct sunlight, rain and snow weather.
No direct sunlight No Rain Exposure
Stay away from
Direct Sunlight
combustibles
24
°C °C
No snow Lay up
Stay away from
Rain Exposure Snow Lay up
antenna cables

4.4 Tool preparation

Tool equipment
Type Image
Name
Bit 10
Φ
Hammer
drill
Crosshead M5
Torque
screwdriver
0.5mm²~6mm²
OT
terminals
press clamp
Utility knife
wire stripper
Rubber
hammer
Crimping
Tool
Euro
terminal
crimping
tool
Individual
Protection Dustproof
Tools
Cover
Installation
Image
Name
DC Voltage
Range ≥1100 V DC
Multimeter
Socket
wrench set
(Hexagon)
Diagonal
poliers
Multifunction
terminal
crimping
tool (RJ45)
Marker
Tape
measure
Hexagon
keys
Spirit level
Protective
glasses
25