Safety Instructions; Scope Of Delivery - Dometic CoolAir SPX1200I Installation Manual

3 Safety Instructions

WARNING! Failure to obey these warnings could result in death or serious injury.
• Only use the parking cooler for the purpose specified by the manufacturer and do not make any al-
terations or structural changes to the device.
• Do not use the parking cooler if it is visibly damaged.
• Installation, maintenance and repair work may only be carried out by qualified personnel from a spe-
cialist company who are familiar with the risks involved and the relevant regulations.
• Do not use the parking cooler near flammable fluids and gases.
• Do not open the system in the event of a fire. Use approved extinguishing agents instead. Do not
use water to extinguish fires.
• Disconnect all connections to the power supply when carrying out work on the device.
NOTICE! Indicates a situation that, if not avoided, can result in property damage.
• The freedom of movement of semi-trailers (of the outer edges of the semi-trailer when turning or
jackknifing) and other vehicle attachments must not be restricted.
• Operating parking cooler with voltages other than those specified can result in damage to the de-
vices.
• Do not operate the parking cooler if the ambient temperature is below 0 °C or above 52 °C.
• se cable ducts to lay cables through walls with sharp edges.
• Do not lay loose or bent cables next to electrically conductive materials (metal).
• Do not pull on the cables.
• Attach and lay the cables in such a manner that they cannot be tripped over or damaged.
• The electrical power supply may only be connected by a specialist workshop.
• The connection to the vehicle's electrical system should be protected as follows:
Power supply: 40 A
Voltage monitor: 2 A
• Never lay power supply lines (battery leads) in the vicinity of signal or control cables.

4 Scope of delivery

Fig.  on page 1
Item Part designation
1
Evaporator unit with connecting cable
2 Edge protection for small holes
3 Edge protection for large holes
4 Clip
5 Screw M6 x 10 mm
6 Cover for clip
7
Hood for rear panel
Quantity
1
2
1
4
4
4
1
EN
15