Dometic CoolAir SPX1200I Installation Manual page 23

1. Switch to the configuration mode.
The display shows P.01 and the
2. Press the
button to change the setting.
The current setting is displayed.
3. Note The level for the low voltage shut-down should not be set any lower than the minimum battery
voltage required to be able to start the engine under any conditions. As a rule that should be no less
than 22 V.
Use the or
The low voltage shut-down setting can be adjusted in 0.1 V increments from 20 V to 23.5 V.
4. Press the
button to save the settings.
The set value is saved and is then applied when the system is restarted. You are then returned to the menu and can
select another menu item by pressing the
P.02: Unit for temperature display
The system can display the room temperature in °C or °F. This parameter can be configured.
1. Switch to the configuration mode.
The display shows P.01 and the
2. Press the
button to change the setting
The current setting is displayed.
3. Use the
or
The display shows P.02 and the symbol lights up.
4. Press the
button to change the setting.
The code for the current setting is displayed:
0: °C 1: °F
5. Use the
or
6. Press the
button to save the settings.
The set value is saved and is then applied when the system is restarted. You are then returned to the menu and can
select another menu item by pressing the
P.05: Tilt sensor
The electronics of the system prevents that the system is switched on when the vehicle is parked at a slope. Since
some vehicles' roof already is tilted, the tilt sensor has to be calibrated to the zero setting before first use.
1. Park the vehicle on a level place.
2. Switch to the configuration mode.
The display shows P.01 and the
3. Press the
button to change the setting
The current setting is displayed.
4. Use the
or
The display shows P.05.
symbol flashes.
button to select the voltage level for low voltage shut-down.
symbol flashes.
button to select the menu item P.02.
button to select the desired temperature unit.
symbol flashes.
button to select the menu item P.05.
or button.
or button.
EN
21