Operation
5.4
Commissioning on Siemens F-CPU
5.4.1
Requirements
The requirement for the commissioning of the EL6930 with a PROFIsafe connection is a safety controller
with PROFIBUS or PROFINET and with a certified PROFIsafe host. Furthermore the Simatic Step7 program
with the extension S7 distributed Safety is needed for the configuration.
5.4.2
Installing the EL6930 in Step7
So that the EL6930 is selectable later in the device catalogue, the device description file for PROFIBUS
(GSD) or PROFINET (GSDML) must be installed first. This can be done in the Step7 program HW Config as
follows:
Fig. 48: Installing the EL6930 in Step7
5.4.3
Configuration of the hardware
First of all the head station must be selected from the device catalogue of the HW Config (CX8031 with
PROFIBUS is used here as an example).
56
Version: 2.0.0
EL6930