Specifications - ICP DAS USA I-7530A-MR-FD User Manual

1.2 Specifications

UART specification:
 Connector: 14-pin screw terminal connector
 COM1: RS-232: (TxD, RxD, GND)
RS-422: (TxD+, TxD-, RxD+, RxD-)
RS-485: (DATA+, DATA-)
 Baud Rate(bps): 300, 600, 1200, 2400, 4800, 9600, 19200, 38400,
57600, 115200, 230400
 Data/Stop bits: 5, 6, 7, 8 / 1, 2
 Parity bit: None, Odd, Even
 Isolation voltage: 3000 V
couple in the UART side
CAN specification:
 CAN interface connector: 9-pin male D-sub (CAN_L, CAN_H,
CAN_GND, and N/A for others)
 CAN Baud Rate(bps): 10 k, 20 k, 50 k, 100 k, 125 k, 250 k, 500 k, 800
k and 1 M (allow user-defined baud rate)
 CAN FD data Baud Rate(bps):100k~10M
 Isolation voltage: 3000 V
photo-couple on CAN bus
 Terminator Resistor: Jumper for 120Ω terminator resistor
 Support Protocol: ISO-11898-2, CAN 2.0A and CAN 2.0B
Power requirement:
 Unregulated +10V DC ~ +30V DC
 Power consumption: 1.5W
 DIP switch: Init (Firmware Update, Module Configuration) / Normal
(Firmware Operation)
Module specs:
 Dimensions: 72mm x 118mm x 35mm (W x L x H)
 Operating temperature: -25 to 75ºC (-13 to 167ºF)
 Storage temperature: -30 to 80ºC (-22 to 176ºF)
 Humidity: 10 to 95%, non-condensing
 LEDs:
PWR LED for power
CAN LED for CAN bus communication
UART LED for UART communication
I-7530A-MR-FD Modbus RTU to CAN Converter User's Manual (Version 1.0, 08/2022) ------------- 7
power protection and 2500V
DC
power protection on CAN side, 3750V
DC
photo-
rms
rms