Fig. 21 Beckhoff Device Manager - Onboard Ethercat P - Beckhoff CP2712 Manual

With the default value of the voltages, you set the value that the voltage has after a cold start. To activate the
default value, you must perform a power cycle after setting the value. For the durability of the memory block,
note that it may be read cyclically but not written cyclically.
To switch the voltages, follow the steps shown in the figure below:
1. In the left area of the Device Manager, select the Hardware tile (1).
2. In the middle area of the Device Manager, select the Equipment tile (2).
3. Select either Enabled or Disabled for the state and default values of the voltages (3).
4. Confirm your selection by clicking on the checkmark on the right (4).
ð You have switched the voltages.
1
Fig. 21: Beckhoff Device Manager - Onboard EtherCAT P
Further interfaces for switching U
in the manual for the Beckhoff Device Manager.
CP27xx
2
3
and U , for example directly from the TwinCAT application, can be found
S P
Version: 2.0
Beckhoff Device Manager
4
35