Table of Contents
Advertisement
Configures the interval the phone sends LLLD-MED packet.
LLDP TX Interval (s)
The default setting is 30s.
Configures whether to enable CDP to receive and/or transmit information from/to CDP-enabled
Enable CDP
devices.
The default setting is "Yes".
Defines the Layer 3 packet's QoS parameter for SIP messages in decimal pattern. This value is used
for IP Precedence, Diff-Serv or MPLS.
Layer 3 QoS for SIP
The default setting is 26 it is equivalent to the DSCP name constant AF31.
Defines the Layer 3 packet's QoS parameter for RTP messages in decimal pattern. This value is used
Layer 3 QoS for
for IP Precedence, Diff-Serv or MPLS.
Audio
The default setting is 46 it is equivalent to the DSCP name constant EF.
Defines the Layer 3 packet's QoS parameters for H.264 messages in decimal pattern. This value is
Layer 3 QoS for
used for IP Precedence, Diff-Serv or MPLS.
Video
The default setting is 34 it is equivalent to the DSCP name constant AF41.
HTTP/HTTPS User-
Sets the user-agent for phonebook and screen saver.
Agent
SIP User-Agent
Sets the user-agent for SIP. Default is "Grandstream GXV34x0 $version""$version" is replaced by
actual firmware version.
Maximum
Transmission Unit
Configures the MTU in bytes. Please set MTU reasonably according to your needs.
(MTU)
Note: If MTU is set to less than 1280, IPv6 may not take effect.
PC Port Mode
Enables and defines the PC port mode. If it is set to "Mirrored", the traffic in the LAN port will go
through PC port as well and packets can be captured by connecting a PC to the PC port. A reboot is
PC Port Mode
required to take effect.
The default setting is "Enabled".
Defines the VLAN Identifier of the Layer 2 frame for PC port. This adds the VLAN tag value on the
target address received from the LAN port of the phone then sends the value to the device
connected to the PC port.
PC Port VLAN Tag
Note: VLAN tag value on the device connected to the PC port should be the same as the VLAN tag
value assigned to the PC port here.
PC Port Priority
Determines the Priority Code Point within a Layer 2 frame header for PC port.
Value
Proxy
Configures the HTTP/HTTPS proxy URI of the network. Some of networks requires going through a
HTTP/HTTPS Proxy
proxy to access to the Internet.
Hostname
The default setting is keeping this field blank.
Configures the HTTP/HTTPS proxy port number of the network. Some of networks requires going
HTTP/HTTPS Proxy
through a proxy to access to the Internet.
Port
The default setting is keeping this field blank.
Defines the specific URI that the phone can directly access to without HTTP/HTTPS proxy. If it is
Bypass Proxy For
filled, the phone will bypass the proxy to send the packets to the specific URI.
The default setting is filed blank.
Remote Control
Indicates whether CSTA Control feature is enabled. Change of this configuration will need the
CSTA Control
system reboot to make it take effect.
Action URI Support
Configures whether the phone is enabled to receive and handle Action URI request.
Advertisement
Table of Contents
