Table of Contents
Advertisement
Configures the phone system to check the SIP User ID in the Request URI of the SIP INVITE
Check SIP User ID for
message from the remote party. If it doesn't match the phone's SIP User ID, the call will be
Incoming INVITE
rejected.
The default setting is "No".
It is used to configure whether to allow SIP Notification message to perform factory reset on the
Allow SIP Reset
phone.
The default setting is "No".
Configures the phone system to authenticate the SIP INVITE message from the remote party. If set
to "Yes", the phone will challenge the incoming INVITE for authentication with SIP 401
Authenticate
Unauthorized response.
Incoming INVITE
The default setting is "No".
Configure this item to validate incoming INVITE, but you must enable authenticate incoming
SIP Realm used for
INVITE first to make it take effect. You can verify the NOTIFY information for the provision,
Challenge INVITE &
including
NOTIFY
make it take effect.
MOH
Loads the MOH (Music on Hold) file to the phone. Click on "Browse" button to upload the music
file from local PC. The MOH audio file has to be in .wav or .mp3 format.
Upload Local MOH
Note: Please be patient while the audio file is being uploaded. It could take more than 3 minutes to
Audio File
finish the uploading especially the file size is large. The button will show as "Processing" during the
uploading. Once done, it will show as "Browse" again. Click on "Save" on the bottom of the web page
and "Apply" on the top of the web page to save the change.
Configures MOH mode. If set to "Local MOH", a local MOH audio file needs to be uploaded for
MOH Mode
this mode to work.
Advanced Features
It is used to set to categorize accounts in server mode groups, the accounts in the same group will
be combined as one and the account widget will display the Caller ID in the account with lowest
ID. The phone can answer any incoming calls to each account in groups.
Virtual Account
If user makes an outbound call, the phone system will use the lowest ID account by default. If the
Group
account fails or SIP INVITE message is timeout, the phone system will failover to the next account
in the group with higher account ID.
If all the accounts are not available in the group, the phone system will traverse all the accounts in
the group and notify the end users the session is failed.
Allows users to synchronize XML phonebook upon receiving SIP NOTIFY message with header
Event: sync-contacts
Allow Sync
Note: Received SIP NOTIFY will be first challenged for authentication purpose before contacting
Phonebook via SIP
configured server to download XML phonebook. The parameters used are the ones configured at
Notify
[Download Contacts]. The authentication can be done either using admin credentials (if no SIP
account is configured) or using SIP account credentials. Default is "Yes".
Account/SIP/Special Features
Special Features
Feature Key
check- sync, resync and reboot, but only when SIP NOTIFY authentication enabled first to
Table 24: Account/SIP/Advanced Settings
Configures phone's settings to meet different vendors' server requirements.
Users can choose from Standard, CBCOM, RNK, China Mobile, ZTE IMS, Mobotix, ZTE NGN, or
Huawei IMS depending on the server type.
This feature is used for BroadSoft / Metaswitch call feature synchronization. When it's set to
BroadSoft / Metaswitch, DND and Call Forward features can be synchronized with BroadSoft /
Call Settings
Advertisement
Table of Contents
