Table of Contents
Advertisement
Configures enable/disable paging call mode of the phone. If set to "Yes", the feature of paging call
Enable Paging Call
will be enabled.
Mode
Default is "No".
Enables the call waiting feature. If it is not checked, the phone system will reject the second
incoming call during an active session without user's knowledge. But this missed call record will be
Enable Call Waiting
saved to remind users.
The default setting is "Yes".
Sets the phone system to play the call waiting tone if there is another incoming call. If it is set to
Enables Call Waiting
"No", the phone will only display the indicator on the LCD screen for another incoming call. The
Tone
default setting is "Yes".
Configures the phone system to play the DND reminder ringtone for the incoming call if the DND
Enable DND
feature is enabled. If it set to "No", the phone will keep mute instead of playing a ring splash to
Reminder Ring
indicate an incoming call when DND is enabled. The default setting is "Yes".
Enables the transfer feature. When set to "No", the phone system will block the TRANSFER key on
Enable Transfer
the LCD screen. The default setting is "Yes".
Hold Call Before
When set to "Yes" the phone holds the second call before completing the attended transfer (it sends
Completing Transfer
the INVITE method to hold the call before sending the REFER method).
Sets the default transfer mode for the phone system. If the Blind Transfer or Attended Transfer
Default Transfer
mode is set, the phone system will use the specific mode to transfer an active call. The users still
Mode
have privilege to switch the mode on the LCD screen when they tap the transfer key.
The default setting is "Blind Transfer".
Programmable Key with the type speed dial, BLF and speed dial via active account will perform as
Enable transfer via
transfer programmable keys under active call. The transfer mode during the call depends on the
non-Transfer
"Default Transfer Mode" mentioned above. MPK can also be selected as forward/transfer
Programmable Key
destination on the ringing screen when [Enable Function for Incoming Call] is set to "Call Transfer".
Enables the preview feature for the incoming video calls. Defines the function for the incoming video
call.
● If it is set to "Preview", the phone system will pop up the PREVIEW key on the LCD screen when
Note: By pressing the preview button, the phone will send the SIP 183 message to the caller's
Special Function for
camera, based on SIP RFC3261; the caller's camera should start sending the stream to the phone
upon receiving the SIP 183.
Incoming Call
At any time, the GXV3480 user can press the "Answer" button. If done, then the phone will send the
SIP 200OK and call will be fully established.
● If set to "Call Transfer", the phone system will pop up the "TRANSFER" key on the LCD screen
The default setting is "None".
Enables the conference. When set to "No", the phone will block the conference application. The
Enable Conference
default setting is "Yes".
Allows the phone system to invite all call parties into a conference by pressing the Conf key. If it is
Auto Conference
disabled, the end user has to add each call party to conference manually. The default setting is "No".
Hold Call before
Configures whether to place the current call on hold before adding new member(s) to a conference.
Adding conferee
If enabled, the current call will be put on hold when the host presses Conference or Add key to invite
new member(s). When an invited member answers the call and agrees to attend the conference, the
host needs to manually resume the conference with the new member added. If disabled, the current
there is an incoming video call, and users could tap on it to check video caller without answering
the incoming video call (the call will keep playing ringback on the caller side).
when there is an incoming call, and users could tap on it to show up the dialer without answering
the incoming call, then, users could transfer this incoming call to others.
Advertisement
Table of Contents
