Table of Contents
Advertisement
TANDBERG MPS User Manual
5.5 MediaBoard Configuration
To configure the IP settings on the Media Boards, open 'MediaBoard IP' as shown in the Figure 5‑6. �edi����rd
configuration.
Figure 5‑6. Mediaboard configuration
For each of the Media Processing Boards the following configuration must de done:
Network ID
1
The Media Processing Board is connected to the same IP-network as the System Controller Board Interface 1.
The Media Processing Board is connected to the same IP-network as the System Controller Board Interface 2.
Ethernet Speed
Auto
The MCU will automatically detect the speed/duplex on the LAN.
10Half
The MCU will connect to the LAN using 10 Mbps/Half Duplex.
10Full
The MCU will connect to the LAN using 10 Mbps/Full Duplex.
100Half
The MCU will connect to the LAN using 100 Mbps/Half Duplex.
100Full
The MCU will connect to the LAN using 100 Mbps/Full Duplex.
IP Address
The IP Address defines the network address of the Media Processing Board. Your LAN administrator will provide you
with the correct address for this field.
IP Subnet Mask
The IP Subnet Mask defines the type of network. Your LAN administrator will provide the correct value for this field.
0
D13373.04
Advertisement
Table of Contents
